![]() ![]() ![]() The 'dynamic desirable' will configure the port to try and become a trunk link by sending a request to the other end of the wire requesting to become a trunk port. The 'dynamic auto' will configure the port to accept incoming negotiation and will accept becoming either a trunk or an access port. The mode you select could be any of the below: This can be configured in a few different ways but will achieve the same result. This allows multiple VLANs to traverse the interface/link. # interface fastethernet Ī trunk is typically a link between two switches or a switch and a router. This can be done with the following commands: ![]() There are two types of switchports: trunk or access.Ī access port is typically for a switch to host connection and this port is assigned to only one VLAN.
0 Comments
Leave a Reply. |